Arma Reforger:Enfusion Blender Tools: MLOD Baking Tutorial - Revision history

Lou Montana: Text replacement - "\{\{GameCategory\|armaR\|Modding\|(Guidelines|Tutorials)\|([^=↵]*)\}\}" to "{{GameCategory|armaR|Modding|$2|$1}}"

2025-02-26T12:31:49Z

Text replacement - "\{\{GameCategory\|armaR\|Modding\|(Guidelines|Tutorials)\|([^=↵]*)\}\}" to "{{GameCategory|armaR|Modding|$2|$1}}"

← Older revision		Revision as of 14:31, 26 February 2025
Line 21:		Line 21:


	{{GameCategory\|armaR\|Modding~~\|Tutorials~~\|Official Tools\|Enfusion Blender Tools}}		{{GameCategory\|armaR\|Modding\|Official Tools\|Enfusion Blender Tools\|Tutorials}}

Lou Montana: Text replacement - "{{Wiki|TODO|Add images}}↵" to ""

2024-03-19T15:56:53Z

Text replacement - "{{Wiki|TODO|Add images}}↵" to ""

← Older revision		Revision as of 17:56, 19 March 2024
Line 1:		Line 1:
	{{TOC\|side}}		{{TOC\|side}}
	~~{{Wiki\|TODO\|Add images}}~~
	A small tutorial for how to bake MLODs with Blender for those who aren't familiar with Blender.		A small tutorial for how to bake MLODs with Blender for those who aren't familiar with Blender.

Lou Montana: Page creation (placeholder)

2022-06-13T11:31:15Z

Page creation (placeholder)

New page

{{TOC|side}}
{{Wiki|TODO|Add images}}
A small tutorial for how to bake MLODs with Blender for those who aren't familiar with Blender.

# Use the EBT importer
# Select LOD0 and the MLOD
# Select the last LOD and navigate to the material section. If you're just rebaking the MLOD and there's an imported MLOD material, remove it and add a new one (if you'll export the model, put the old one back in after you're done with this).
# Add an image texture to the material
# Create an empty texture
# Go to render properties and change the render engine to Cycles
# Scroll down and open Bake
# Switch bake type to Diffuse and set Contributions to color only
# Check Selected to Active and set the extrusion (or also max ray distance) to a distance that will cover the differences between your MLOD and LOD0. If there's transparency where there shouldn't be any, adjust the extrusion distance
# Right click on the corner of the area with the model, select vertical split and click somewhere in the area with the model to create a new area
# Switch the area/editor type to image editor
# Select all by pressing "A" (or select the objects that belong to LOD0 and the last LOD) and make sure the last LOD is highlighted in yellow. If it's orange, "Ctrl+left click" it until it is.
# Press Bake and wait
# The resulting texture will appear in the image editor where you can save it
# Set the file format to TIFF and very importantly, set the compression to LZW.

Done! :-)

{{GameCategory|armaR|Modding|Tutorials|Official Tools|Enfusion Blender Tools}}