From Bohemia Interactive Community
Jump to navigation
Jump to search
Template:Command
Notes
- Posted on 16 Feb, 2007
- Dr_Eyeball
-
getPos obj select 2
might return the vertical position above ground level, but for a stacked object, it returns the vertical position above the object beneath it. The same problem exists for getPosASL. There was a discussion thread in the BIS forums which suggested the use of the command modelToWorld instead to get around this issue where an absolute vertical position is required. ArmA Ver 1.02.
- Posted on 14 Dec, 2010
- disat
-
This command returns a PositionAGL. Apparently, Position and PositionAGL are the same thing.
- Posted on 6 Feb, 2011
- Hduregger
-
The z height returned changes dynamically with the height of waves beneath the object, if the object is located over sea. The z height returned by getPosATL and getPosASL does not change like this. This was tested by continuously retrieving the position of a static object, like the cross in the empty/corpses category, placed over sea or land.
getPos behaves similar to
_obj modelToWorld [0.0, 0.0, 0.0]
but it does not give the same result, therefore
(_obj modelToWorld [0.0, 0.0, 0.0]) is not the same as (getPos _obj).
- Posted on 23 Nov, 2011
- Tankbuster
-
You can use getPos and setPos on triggers.
Bottom Section