Jump to navigation Jump to search
- Returns the object position in format Position.
- Array = getPos object
- object: Object; since VBS2 1.24: Location
- Return Value:
- Array - format Position
- Example 1:
Report bugs on the Feedback Tracker and/or discuss them on the Arma Discord or on the Forums.
Only post proven facts here! Add Note
- Posted on 16 Feb, 2007
- getPos obj select 2 might return the vertical position above ground level, but for a stacked object, it returns the vertical position above the object beneath it. The same problem exists for getPosASL. There was a discussion thread in the BIS forums which suggested the use of the command modelToWorld instead to get around this issue where an absolute vertical position is required. ArmA Ver 1.02.
- Posted on 14 Dec, 2010
- This command returns a PositionAGL. Apparently, Position and PositionAGL are the same thing.
- Posted on 6 Feb, 2011
- The z height returned changes dynamically with the height of waves beneath the object, if the object is located over sea. The z height returned by getPosATL and getPosASL does not change like this. This was tested by continuously retrieving the position of a static object, like the cross in the empty/corpses category, placed over sea or land. getPos behaves similar to _obj modelToWorld [0.0, 0.0, 0.0] but it does not give the same result, therefore (_obj modelToWorld [0.0, 0.0, 0.0]) != (getPos _obj).
- Posted on 23 Nov, 2011
- You can use getPos and setPos on triggers.
- Scripting Commands
- Introduced with Operation Flashpoint version 1.00
- Operation Flashpoint: New Scripting Commands
- Operation Flashpoint: Scripting Commands
- Command Group: Uncategorised
- Scripting Commands OFP 1.96
- Scripting Commands OFP 1.46
- Scripting Commands ArmA
- Command Group: Object Information
- Scripting Commands ArmA2
- Scripting Commands Arma 3
- Scripting Commands Take On Helicopters